Paragon 8080 Use and Care Manual download pdf (Page 11)

ASSEMBLING THE TONG HOOK

Comes with:

 Two Hex Screws

 Two Locknuts

Tools needed:

 1/4” Hex Nut Driver

 11/32” Hex Nut Driver

Directions:

With the classic dog facing you, look for the two holes on the right side of

the machine. The holes on the machine should line up with the holes on

the tong hook. Place the two screws through the holes on the tong hook

and then through the holds on the machine. While holding the screws in

place, attach the locknuts from the inside of the machine until tight. See

figure below.

Inside of Machine View Outside of Machine View

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

No comments

Paragon 8080 Use and Care Manual Page 11